Technical Manual

59
Initial setting
Display details setting
F1 F2 F3 F4
Display details
Cursor Cursor
Select:
Clock
Temperature
1
Room temp.
Auto mode
No 24h
Yes / No
Yes / No
F1 F2 F3 F4
Display details
Select:
Clock
Temperature
Room temp.
Auto mode
No 24h
Yes / No
Yes / No
Cursor Cursor
1
Main
Sub
Button operation
[
1
]
Move the cursor to the "Display details" with the F1 or F2 button, and
press the
button.
Select "Initial setting" from the Main menu (refer to page 19), and press the
button.
Move the cursor to the "Temperature", "Room temp." or "Auto mode" with
the F1
or F2 button, and change the setting with the F3 or F4 button.
Temperature Unit, Room temp, Auto mode
[
2
]
Change the setting with the F3 or F4 button.
Press the
button to save the settings.
[1] Temperature unit setting (The factory default setting is Celsius (˚C))
• ˚C: Temperature is displayed in Centigrade. Temperature is disp;ayed in
0.5- or 1-degree increments, depending on the model of indoor units.
• ˚F: Temperature is displayed in Fahrenheit.
• 1˚C: Temperature is displayed in Centigrade in 1-degree increments. This
item will not appear on a sub remote controller.
[2] Room temperature display (The factory default setting is "Yes")
• Yes: Room temperature appears on the Main display.
• No: Room temperature does not appears on the Main display.
Note: Even when "Yes" is set, the room temperature is not displayed on
the Main display in the “Basic”mode.
[3] Auto mode setting (The factory default setting is "Yes")
• Yes: "AUTO COOL" or "AUTO HEAT" is displayed during operation in the
AUTO (single set point) mode.
• No: Only "AUTO" is displayed during operation in the AUTO (single set
point) mode.
Navigating through the screens
• To go back to the Main menu ..................
button
• To return to the previous screen ..............
button