Technical Manual
33
Controller operation : Function setting
[
5
]
F1 F2 F3 F4
Weekly timer
Input display:
day Select Page
Mon Tue Wed Thu Fri Sat Sun
No.
6: 3
1 : 2 - 27
Weekly timer
Select:
Cursor Content
Thu
No.
On
Auto
F1 F2 F3 F4
Weekly timer
Day selection:
Thu
Changes saved
Cool
Room
AutoSet temp.
Mode Temp. Fan
Fri
F1 F2 F3 F4
Weekly timer
Weekly timer
Select:
Cursor Content
Day selection:
Thu
Thu
No.
Changes saved
On
F1 F2 F3 F4
Weekly timer
Weekly timer
Select:
Cursor Content
Day selection:
Thu
Thu
No.
Changes saved
On
[
4
]
The weekly timer setting screen will appear and the current settings will be dis-
played.
Up to eight operation patterns can be set for each day.
Move the cursor to the desired day of the week with the F1
or F2 button,
and press the
F3
button to select it. (Multiple days can be selected.)
Press the
button.
Navigating through the screens
•
To go back to the setting change/day of the week selection screen
.... button
• To go back to the Main menu .....................................................
button
• To return to the previous screen ................................................
button
will appear on the Main display in the Full mode when
the weekly timer setting for the current day exists.
The icon will not appear while the On/Off timer is enabled
or the system is under centralized control (Timer operation
from local remote controller is prohibited).
• Time: settable in 5-minute increments
* Press and hold the button to rapidly advance the numbers.
• On/Off/Auto: Selectable settings depend on the model of connected indoor
unit. (When an Auto pattern is executed, the system will operate in the Auto
(dual set point) mode.)
• Temperature: The settable temperature range depends on the connected
indoor units. (1ºC increments)
When the Auto (dual set point) mode is selected, two preset temperatures
can be set. If an operation pattern with a single preset temperature setting
is executed during the Auto (dual set point) mode, its setting will be used as
the cooling temperature setting in the Cool mode.
Operation pattern setting screen will appear.
Press the F1
button to move the cursor to the desired pattern number.
Move the cursor to the time, On / Off, or temperature with the F2
button.
Change the settings with the F3
or F4 button.
Press the
button to save the settings.
A conrmation screen will appear.