Technical Manual

10
Names and functions of controller components
Display
Fri
Mode Temp. Fan
Room
Cool Auto
Set temp.
Centrally controlled
Fri
Cool
Mode Temp. Fan
AutoSet temp.
Centrally controlled
The main display can be displayed in two different modes: "Full" and "Basic".
T
he factory setting is "Full". To switch to the "Basic" mode, change the setting on the Main display setting.
(Refer to page 50)
<Full mode> <Basic mode>
* All icons are displayed for explanation.
1
1
2
2
5
5
9
8
7
6
3 3
4
4
9
@
#
)
!
1
#
0
2 3 4 5 6 7 8
Fan speed setting appears here.
4 Fan speed Page 18
Appears while the units are operated in the
energy-save mode. (Will not appear on some
models of indoor units)
Appears while the outdoor units are operated in
the silent mode.
Preset temperature appears here.
Appears when the ON/OFF operation is centrally
controlled.
Current time appears here.
Appears when the buttons are locked.
Indoor unit operation mode appears here.
Appears when the operation mode is centrally
controlled.
5 93 egaP
6 43 egaP
2 Preset temperature Page 17
6
2 83 egaP
1 Operation mode Page 16
7
Indicates the vane setting.
8 12 egaP
Indicates the louver setting.
Indicates the ventilation setting.
Appears when the On/Off timer (Page 24),
Night setback (Page 43), or Auto-off timer
(Page 26) function is enabled.
appears when the timer is disabled by the
centralized control system.
9 22 egaP
) 22 egaP
3 Page 24, 26, 43
Indicates when filter needs maintenance.
Appears when the filter reset function is centrally
controlled.
Appears when the preset temperature is centrally
controlled.
0 82 egaP
9
8
Appears when the Weekly timer is enabled.
4 23 egaP
Appears when the preset temperature range is
restricted.
! 63 egaP
Functions of the corresponding buttons appear
here.
5 Button function guide
Appears when the built-in thermistor on the
remote controller is activated to monitor the
room temperature (
1
).
appears when the thermistor on the
indoor unit is activated to monitor the room
temperature.
7
Most settings (except ON/OFF, mode, fan
speed, temperature) can be made from
the Main menu. (Refer to page 19.)
3 Clock
(See the Installation Manual.)
Current room temperature appears here.
1 Room temperature
(See the Installation Manual.)
Appears when an energy-saving operation is
performed using a "3D i-See sensor" function.
Appears for a certain period of time when a
centrally-controlled item is operated.
@
# Centrally controlled