Installation Manual
7
5 Install the bottom case.
■ Installation using a switch box
Secure at least two corners of the switch box with screws.
■ Direct wall installation
Thread the cable through the groove.
Secure at least two corners of the remote controller with screws.
Be sure to secure top-left and bottom-right corners of the remote controller (viewed from the front) to prevent it from lifting.
(Use molly anchor etc.)
6 Cut out the cable access hole.
■ Direct wall installation (when running the cable along the wall)
Insert a flat-tip screwdriver with a blade width of 47 mm (5/329/32 inch) or a
Plate service tool into either of the two latches at the bottom of the remote
controller, and move it in the direction of the arrow as shown in the figure at
right.
The top case will come loose from the front cover. Pull the top case toward
you to remove it.
Cut out the thin-wall part on the front cover (indicated with the shaded area in
the right figure) with a nipper.
(This cutout hole will be used to thread the remote controller cable through,
after the cable is threaded through the groove on the back of the bottom case.)
Place the top case onto the front cover.
7 Route the wire to the top case.
Connect the connector on the bottom case to the connector on the top case.
■ Installation using a switch box ■ Direct wall installation
Seal the cable access
hole with putty.
Double switch box
Roundhead cross
slot screws
Remote controller
cable
Wood
screw
Remote controller
cable
Thread the cable
through the groove.
Refer to 2.
Refer to 4.
Refer to 4.
To avoid damage to the controller, do not overtighten the screws. To avoid damage to the controller, do not make holes on the controller
cover.
Important
To prevent damage to the circuit board, remove the front cover from
the top case before cutting out a cable access hole.
Notice
or
Plate service tool
Front cover
Top case
Securely connect the
connectors.
To prevent malfunctions, do not remove the protective film or the
circuit board from the casing.
To prevent cable breakage and malfunctions, do not hang the top
controller casing hang by the cable.
Important
Protection
Sheet
WT08394X01_GB_A5.book 7 ページ ２０１６年９月２６日 月曜日 午後７時１４分