Operation Manual

EN-22
8. ProjectorView
E-mail notification feature
When there is something wrong with the projector, an E-mail notification is automatically sent to the designated
address to post an alert or error message.
To use this feature, enter the SMTP IP address, E-mail address, and E-mail from in the Setup window.
(For details, see “8.3. Entering projector information”.)
Once you have configured the above settings, the E-mail notification feature remains enabled even after your web
browser (the ProjectorView window) is closed.
An example: Sending an alert message when the lamp 1 change required.
ProjectorView Alert:
Thelamphasreachedthemaximumusagetime.
Replace the lamp and reset the lamp counter.
Please see the user manual for detailed instructions.
Projector name : abc
Projectormodel:XY1234
Serial number : 12345
Installeddate:2008/01/01
Installed location : 10Factory-5F
Operation time : 2146 hours, 43 minutes
Lamp 1 time : 4000 hours, 0 minutes
Lamp 2 time : 1536 hours, 25 minutes
Lastlampreplaceddate:2008/01/01
Lastmaintenancedate:2008/01/01
“Projector model” varies depending on the type of projectors.
<Note>
• Forapprox.10secondsaftertheprojectorispoweredon,theLANandserialRS-232Ccommandscannotbe
controlled.
• TheLANcommandhascontrolpriorityovertheRS-232Ccommandwhenbothcommandsareexecuted
simultaneously.
• Youcannotswitchlampmodeormutemodeonandoffwhilethetestpatternisbeingdisplayedorpassword
is being entered.
• Theprojectormaybeslowinrespondingdependingonthestatusoftheprojector.
• Somedevices(routers)maynotoperateinDHCPmode.
• Forapprox.oneminuteafterexecutingtheONandOFFcommands,othercommandscannotbeexecuted.