Operation Manual

Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)
5-30 Features and controls
5
4. Insert the first valid F.A.S.T.-key into the
emergency key.
5. Turn the emergency key with the
F.A.S.T.-key to the “ON” position for 5
seconds.
6. Turn the emergency key with the
F.A.S.T.-key to the “LOCK” position.
Within 30 seconds after doing so, remove
the F.A.S.T.-key from the emergency key,
insert the second valid F.A.S.T.-key into
the emergency key and turn it to the “ON”
position. About 10 seconds later, the
immobilizer display will start to blink.
7. When the immobilizer display starts
blinking, turn the second valid F.A.S.T.-
key to the “LOCK” position and remove
it. Within 30 seconds after doing so, insert
a blank F.A.S.T.-key into the emergency
key and turn it to the “ON” position. Per-
form this operation no more than 30 sec-
onds after the immobilizer display starts
blinking. When registration of the ID
code is complete, the immobilizer display
will come on for 3 seconds then go off. If
an error occurs, the immobilizer display
will go off during the procedure.
8. If you wish to register another F.A.S.T.-
key, repeat the process from step 1.
N00515500141
Press the remote control transmitter buttons
to lock or unlock the doors and to open the
trunk lid.
It can also help you signal for attention by
setting off the panic alarm.
NOTE
Perform the operation when the interrupt dis-
play screen is not showing. The interrupt dis-
play screen may prevent you from seeing the
immobilizer display.
It is not possible to register a F.A.S.T.-key if:
the immobilizer display goes off during the
procedure
the immobilizer display does not come on
within 30 seconds after turning the ignition
switch to the “ON” position with a blank
F.A.S.T.-key
The procedure will be terminated automati-
cally if:
a period of 30 seconds or longer elapses
from the moment when the first F.A.S.T.-
key is turned to the “LOCK” position to the
moment when the second F.A.S.T.-key is
turned to the “ON” position
a period of 30 seconds or longer elapses
from the moment when the second
F.A.S.T.-key is turned to the “LOCK” posi-
tion to the moment when the blank
F.A.S.T.-key is turned to the “ON” position
To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to “Keyless entry system: Cus-
tomer F.A.S.T.-key programming” on page
5-33.
Keyless entry system
NOTE