Operation Manual

Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)
5-24 Features and controls
5
The engine will start only by using the emer-
gency key with the F.A.S.T.-key inserted. It is
possible to use all electrical accessories with
only the emergency key.
Engages the starter. Release the emergency
key when the engine starts. The ignition
switch returns automatically to the “ON”
position.
1. Remove the emergency key from the
F.A.S.T.-key.
Refer to “Emergency key” on page 5-23.
2. While pushing the lock release buttons
(A), remove the cover of the ignition
switch.
3. Insert the emergency key into the ignition
switch, and slowly push and turn.
1. [For vehicles with manual transaxle]
Push the emergency key in at the “ACC”
position and keep it depressed until it is
turned to the “LOCK” position, and
remove.
[For vehicles with continuously variable
transmission (CVT) or Twin Clutch SST]
First, set the selector lever (CVT) or the
gearshift lever (Twin Clutch SST) to the
“P” (PARK) position, and then slowly
turn the ignition switch to the “LOCK”
position while pressing it.
ON
START
NOTE
 Your vehicle is equipped with an electronic
immobilizer. To start the engine, the ID code
which the F.A.S.T.-key sends must match the
one registered to the immobilizer computer.
(Refer to “Electronic immobilizer (Anti-theft
starting system)” on page 5-28.)
To turn from “LOCK” to “ACC”
NOTE
 When the ignition switch cannot be turned
from the “LOCK” position to the “ACC”
position, turn the ignition switch while turn-
ing the steering wheel in both directions.
To turn from “ACC” to “LOCK”