Operation Manual

Replacement of light bulbs
Vehicle care and maintenance 9-45
9
4. Remove the bulb by pulling it out.
5. To install the bulb, perform the removal
steps in reverse.
1. Open the trunk lid.
Remove the clips (A) and remove the
cover (B).
2. Remove the socket and bulb assemblies
by turning them counterclockwise.
3. Remove the bulb by pulling it out.
4. To install the bulb, perform the removal
steps in reverse.
N00944000331
1. Remove the screws (A) from the license
plate light lens (B). Then, remove the lens
and gasket (C), and withdraw the bulb.
NOTE
 When mounting the light unit, align the pins
(E) on the light unit with the holes in the
body.
Rear side-marker
light
Tail and stop light and
Rear turn signal light
Tail lights and back-up lights
C- Tail light
D- Back-up light
License plate light
Tail light
Back-up light