Operation Manual

Replacement of light bulbs
Vehicle care and maintenance 9-37
9
N00943100885
1. When replacing the bulb on the front pas-
senger’s side, remove the bolt (A) holding
down the washer tank spout and move the
spout toward the rear of the vehicle.
2. Turn the cap (B) counterclockwise to
remove it.
3. Turn the bulb (C) counterclockwise to
remove it.
4. While holding down the tab (D), pull out
the bulb (E).
5. To install the bulb, perform the removal
steps in reverse.
Headlights (high beam, except
for vehicles with high intensity
discharge headlights)
*- Front of the vehicle
*- Front of the vehicle
*- Front of the vehicle
CAUTION
 Handle halogen light bulb with care. The gas
inside a halogen light bulb is highly pressur-
ized, so dropping, knocking, or scratching a
halogen light bulb can cause it to shatter.
 Never hold the halogen light bulb with a bare
hand, dirty glove, etc.
The oil from your hand could cause the bulb
to break the next time the headlights are
used.
If the glass surface is dirty, clean it with
alcohol and let it dry completely before
installing the bulb.