Operation Manual

Replacement of light bulbs
9-36 Vehicle care and maintenance
9
N00943100872
1. For vehicles equipped with turbocharger,
when replacing the bulb on the driver’s
side, remove the bolt (A) holding down
the relay box and move the relay box
toward the rear of the vehicle.
2. For vehicles equipped with turbocharger,
when replacing the bulb on the passen-
ger’s side, lift up the engine coolant reser-
voir (B).
3. Turn the bulb (C) counterclockwise, and
then remove the headlight bulb with
holder.
4. While holding down the tab (D), pull out
the bulb (E).
5. To install the bulb, perform the removal
steps in reverse.
Headlights (low beam, except
for vehicles with high intensity
discharge headlights)
*- Front of the vehicle
*- Front of the vehicle
*- Front of the vehicle
CAUTION
 Handle halogen light bulb with care. The gas
inside a halogen light bulb is highly pressur-
ized, so dropping, knocking, or scratching a
halogen light bulb can cause it to shatter.
 Never hold the halogen light bulb with a bare
hand, dirty glove, etc. The oil from your
hand could cause the bulb to break the next
time the headlights are used.
If the glass surface is dirty, clean it with
alcohol and let it dry completely before
installing the bulb.