Operation Manual

Replacement of light bulbs
Vehicle care and maintenance 9-33
9
2. There is a fuse puller (A) in the engine
compartment fuse block.
3. Clamp it on the fuse you wish to remove,
and pull the fuse straight out from the fuse
block.
4. Use the fuse location diagrams and the
matching tables, to check the fuse that is
related to the problem. If the fuse is not
blown, something else must be causing
the problem. Contact an authorized Mit-
subishi Motors dealer or a repair facility
of your choice to have the problem
checked.
5. Insert a new fuse of the same capacity
securely into the appropriate slot.
N00942900219
Before replacing a bulb, be sure the light is
off. Do not touch the glass part of the new
bulb with your bare fingers; the oil from your
skin will stay on the glass and dim or destroy
the bulb when it gets hot.
B- Fuse is OK
C- Blown fuse
CAUTION
 Never use a fuse with a capacity greater than
the one listed or any substitute, such as wire,
foil etc. This would cause the circuit wiring
to heat up and could cause a fire.
 If the replacement fuse blows again after a
short time, have the electrical system
checked by an authorized Mitsubishi Motors
dealer or a repair facility of your choice to
find and correct the cause.
Replacement of light bulbs
CAUTION
 Bulbs are extremely hot immediately after
being turned off.
When replacing a bulb, wait for it to cool
sufficiently before touching it. You could
otherwise be burned.
NOTE
 If you are unsure of how to carry out the
work as required, it is recommended that
these procedures be carried out by an autho-
rized Mitsubishi Motors dealer or a repair
facility of your choice.
 Be careful not to scratch the vehicle body
when removing a light and lens.
CAUTION