Operation Manual

Brake fluid/Clutch fluid (if so equipped)
Vehicle care and maintenance 9-13
9
Check the washer fluid level at regular inter-
vals and add washer fluid to reservoir if nec-
essary.
Open the reservoir cap and check the fluid
level with the dipstick.
When freezing weather is anticipated, flush
out the water in the reservoir by operating the
pump. Fill the reservoir with windshield anti-
freeze (not radiator antifreeze), and operate
the system for a few seconds to flush out the
residual water.
N00938700186
The brake fluid and the clutch fluid share the
reservoir tank.
The fluid level must be between the “MAX”
and “MIN” marks on the reservoir.
The fluid level falls slightly with wear of the
brake pads, but this does not indicate any
abnormality.
The fluid in the master cylinder should be
checked when doing other work under the
engine hood. The brake system should also be
checked for leaks at the same time.
If the fluid level falls markedly in a short
length of time, it indicates leaks from the
brake system.
If this occurs, have the vehicle checked by an
authorized Mitsubishi Motors dealer or a
repair facility of your choice.
Use the recommended brake fluid conform-
ing to DOT 3 or DOT 4. The reservoir cap
must be tightly sealed to keep dirt and water
out.
During cold weather
Brake fluid/Clutch fluid (if so
equipped)
To check the fluid level
MAX
MIN
Fluid type
CAUTION
 Do not let any petroleum-based fluid touch,
mix with, or get into the brake fluid. This
will damage the seals.
 Be careful when handling brake fluid. It can
damage painted surfaces.
 Use only the listed brake fluid. Different
brands of brake fluid have different addi-
tives, and these can cause a chemical reac-
tion. Do not mix brands of brake fluid.
 Keep the reservoir tank cap closed to keep
the brake fluid from evaporating.