Operation Manual

How to change a tire
8-10 For emergencies
8
5. Remove the wheel nuts with the wheel nut
wrench, then take the wheel off.
6. Clean out any mud, etc. on the hub sur-
face (F), hub bolts (G) or in the installa-
tion holes (H) in the wheel, and then
mount the spare tire.
WARNING
 Stop jacking up the vehicle as soon as the
tire is raised off the ground. It is danger-
ous to raise the vehicle any higher.
 Never get under the vehicle or put any
portion of your body under the vehicle
while it is supported by the jack.
 Do not bump the raised vehicle or leave it
sitting on the jack for a long time. Both
are very dangerous.
 Do not use a jack except the one that came
with your vehicle.
 The jack should not be used for any pur-
pose other than to change a tire.
 No one should be in your vehicle when
using the jack.
 Do not start or run the engine while your
vehicle is on the jack.
 Do not turn the raised wheel. The tires
that are still on the ground could turn and
make your vehicle fall off the jack.
CAUTION
 Handle the wheel carefully when changing
the tire, to avoid scratching the wheel sur-
face.
WARNING
 Mount the spare wheel with the valve stem
(I) facing outboard. If you cannot see the
valve stem (I), you have installed the
wheel backwards.
Operating the vehicle with the spare wheel
installed backwards can cause vehicle
damage and result in an accident.