Operation Manual

Automatic air conditioning with Fahrenheit scale (if so equipped)
7-20 Comfort controls
7
 Disable automatic air control:
Even when the mode selection dial or the
blower speed selection dial is set to the
“AUTO” position, the air selection switch
will not be automatically controlled.
 Changing the settings
Press the air selection switch for about 10
seconds or longer.
When the setting has changed, the system
will beep and the indicator light will flash.
• When the setting has changed from
enabled to disabled,
the system will beep three times and the
indicator will flash three times.
• When the setting has changed from dis-
abled to enabled,
the system will beep two times and the
indicator light will flash three times.
N00737300297
Push the switch, and the air conditioning
compressor will turn on. The air conditioning
indicator light (A) will come on.
A sound will be made every time you push
the switch.
Push the switch again and the air condition-
ing compressor will stop and the indicator
light (A) goes off.
N00759800032
You can change the following functions to
match your preference.
NOTE
 The factory setting is “Enable automatic air
control”.
 While the mode selection dial is set between
“ ” and “ ” position, the air selection
will automatically change to the outside air
position, even if the system is set to “Disable
automatic air control”, in order to prevent
windows from fogging up.
Air conditioning switch
CAUTION
 When using the air conditioning, the idling
speed may slightly increase as the air condi-
tioning compressor is switched on/off auto-
matically. Especially for vehicles with a
continuously variable transmission (CVT) or
Twin Clutch SST, while the vehicle is sta-
tionary, fully depress the brake pedal to pre-
vent the vehicle from creeping.
NOTE
 If a problem is detected in the air condition-
ing compressor, the air conditioning indica-
tor light (A) blinks. Press the air
conditioning switch once to turn it off, then
once more to turn it back on. If the air condi-
tioning indicator light does not blink there is
no problem. If it does blink, have it checked
at an authorized Mitsubishi Motors dealer or
a repair facility of your choice.
 Sometimes, for example after using a high-
pressure car wash, the condenser can get wet,
and the air conditioning indicator light (A)
blinks temporarily. Wait for a while, press
the air conditioning switch once to turn the
system off, then once more to turn it back on.
Once the water evaporates, the blinking will
stop.
Personalizing the air conditioning
switch (Changing the function set-
ting)