Operation Manual

Manual air conditioning with MAX A/C mode (if so equipped)
Comfort controls 7-11
7
N00731200278
For ordinary cooling
1. Set the mode selection dial to the “ ”
position.
2. Push the air selection switch (A) to set it
to the outside air position.
3. Push the air conditioning switch (B).
4. Change the temperature by turning the
control dial clockwise or counterclock-
wise.
5. Set the desired blower speed.
For quick cooling
1. Set the mode selection dial to the “ ”
position.
2. Set the temperature control dial to the
“MAX A/C” position.
3. Set the blower speed to the highest posi-
tion.
N00731300211
Set the mode selection dial to one of the posi-
tions shown in the illustration and set the air
selection switch (A) to the outside air posi-
tion.
Warm air flows to the leg area and unheated
or slightly warm air (depending upon the
position of the temperature control dial) flows
to the upper part of the passenger compart-
ment.
Cooling
NOTE
 If the outside air is dusty or contaminated in
some way, push the air selection switch (A)
to set it to the recirculation position. Let in
some outside air from time to time for good
ventilation.
 To cool the leg areas, set the mode selection
dial to the “ ” position.
NOTE
 When the temperature control dial is set to
the “MAX A/C” position, the air condition-
ing compressor will run automatically and
the light will come on. The recirculation
position will be selected automatically. In
this case, you cannot turn the air condition-
ing off or select the outside air position.
NOTE
 When the temperature control dial is set to a
position other than “MAX A/C”, the air
selection will automatically change to out-
side air. The air conditioning will revert to
the previous condition in which the “MAX
A/C” position was not selected.
Combination of unheated air and
heated air
NOTE
SC00000800-5.fm 11 ページ ２０１３年２月１５日 金曜日 午後３時３１分