Operation Manual

Manual air conditioning with MAX A/C mode (if so equipped)
7-10 Comfort controls
7
Push the switch again and the air condition-
ing compressor will stop and the indicator
light (A) goes off.
N00731100222
Set the mode selection dial to the “ ” posi-
tion and set the air selection switch (A) to the
outside air position.
Turn the temperature control dial clockwise
or counterclockwise to the desired tempera-
ture. Select the best speed to fit your needs.
CAUTION
 When using the air conditioning, the idling
speed may slightly increase as the air condi-
tioning compressor is switched on/off auto-
matically. Especially for vehicles with a
continuously variable transmission (CVT) or
Twin Clutch SST, while the vehicle is sta-
tionary, fully depress the brake pedal to pre-
vent the vehicle from creeping.
NOTE
 If a problem is detected in the air condition-
ing compressor, the air conditioning indica-
tor light (A) blinks. Press the air
conditioning switch once to turn it off, then
once more to turn it back on. If the air condi-
tioning indicator light (A) does not blink,
there is no problem. If it does blink, have it
checked at an authorized Mitsubishi Motors
dealer or a repair facility of your choice.
 Sometimes, for example after using a high-
pressure car wash, the condenser can get wet,
and the air conditioning indicator light (A)
blinks temporarily. Wait for a while, press
the air conditioning switch once to turn the
system off, then once more to turn it back on.
Once the water evaporates, the blinking will
stop.
Operating the air conditioning
system
Heating
NOTE
 For quick heating, set the blower speed
selection dial to the position shown in the
illustration.