Operation Manual

Manual air conditioning with MAX A/C mode (if so equipped)
Comfort controls 7-9
7
If the outside air is dusty or contaminated in
some way, use the recirculation position.
Switch to the outside air position every now
and then to keep the windows from fogging
up.
N00702100015
You can change the following functions to
match your preference.
 Enable automatic air control:
When the air conditioning operates, the
air selection switch will be automatically
controlled.
 Disable automatic air control:
Even when the air conditioning operates,
the air selection switch will not be auto-
matically controlled.
 Changing the settings
Press the air selection switch for about 10
seconds or longer.
When the setting has changed, the system
will beep and the indicator light will flash.
• When the setting has changed from
enabled to disabled,
the system will beep three times and the
indicator will flash three times.
• When the setting has changed from dis-
abled to enabled,
the system will beep two times and the
indicator light will flash three times.
N00731000423
Push the switch, and the air conditioning
compressor will turn on. The air conditioning
indicator light (A) will come on.
A sound will be made every time you push
the switch.
CAUTION
 Using recirculated air for a long time may
cause the windows to fog up.
NOTE
 While the mode selection dial is set between
“ ” and “ ” position, the air condition-
ing compressor will run automatically. The
outside air position will also be selected
automatically. (In this case, the air condition-
ing indicator will not change.)
 When the temperature control dial is set to
the “MAX A/C” position, the air selection
will be automatically set to the recirculation
position.
 When the temperature control dial is in the
“MAX A/C” position, if it is set to a position
other than “MAX A/C”, the setting for the
air selection switch is selected as described
below. The selection of recirculated air or
outside air depends on the setting before
“MAX A/C” was used.
• If automatic control was set:
Automatic control is continued
• If recirculated air was selected:
Recirculated air is continued
• If outside air was selected:
Outside air is continued
Personalizing the air selection
(Changing the function setting)
NOTE
NOTE
 The factory setting is “Enable automatic air
control”.
 While the mode selection dial is set between
“ ” and “ ” position, the air selection
will automatically change to the outside air
position, even if the system is set to “Disable
automatic air control”, in order to prevent
windows from fogging up.
Air conditioning switch