Operation Manual

Bluetooth® 2.0 interface (if so equipped)
5-166 Features and controls
5
With the confirmation function activated, you
are given more opportunities than normal to
confirm a command when making various
settings to the Bluetooth
®
2.0 interface. This
allows you to decrease the possibility that a
setting is accidentally changed.
The confirmation function can be turned on
or off by following the steps below.
1. Press the SPEECH button (except for
vehicles with Mitsubishi Multi-Commu-
nication System) or PICK-UP button (for
vehicles with Mitsubishi Multi-Commu-
nication System).
2. Say “Setup.”
3. Say “Confirmation prompts.”
4. The voice guide will say “Confirmation
prompts are <on/off>. Would you like to
turn confirmation prompts <off/on>.”
Answer “Yes” to change the setting or
answer “No” to keep the current setting.
5. The voice guide will say “Confirmation
prompts are <off/on>” and then the sys-
tem will return to the main menu.
N00564601118
It is possible to use a passcode as a security
function by setting a passcode of your choice
for the Bluetooth
®
2.0 interface.
When the security function is turned on, it is
necessary to make a voice input of a 4-digit
passcode in order to use all functions of the
Bluetooth
®
2.0 interface, except for recep-
tion.
Use the following procedure to turn on the
security function by setting a passcode.
1. Press the SPEECH button (except for
vehicles with Mitsubishi Multi-Commu-
nication System) or PICK-UP button (for
vehicles with Mitsubishi Multi-Commu-
nication System).
2. Say “Setup.”
3. Say “Passcode.”
4. The voice guide will say “Passcode is dis-
abled. Would you like to enable it?”
Answer “Yes.”
Answer “No” to cancel the setting of the
passcode and return to the main menu.
5. The voice guide will say “Please say a 4-
digit passcode. Remember this passcode.
It will be required to use this system.”
Say a 4-digit number which you want to
set as a passcode.
6. For confirmation purposes, the voice
guide will say “Passcode <4-digit pass-
code>. Is this correct?” Answer “Yes.”
Answer “No” to return to the passcode
input in Step 5.
7. When the registration of the passcode is
completed, the voice guide will say “Pass-
code is enabled” and the system will
return to the main menu.
If a passcode has been set and the security
function is enabled, the voice guide will say
“Hands-free system is locked. State the pass-
code to continue” when the SPEECH button
(except for vehicles with Mitsubishi Multi-
Communication System) or PICK-UP button
(for vehicles with Mitsubishi Multi-Commu-
nication System) is pressed to enter voice rec-
ognition mode. Say the 4-digit passcode
number to enter the passcode.
If the entered passcode is wrong, the voice
guide will say “<4-digit passcode>, Incorrect
Security function
Setting the passcode
NOTE
 Passcode will be required to access the sys-
tem after the next ignition cycle.
 It is required for a little time after engine
stop that the entered passcode is actually
recorded in the system. If the ignition switch
is made to “ACC” or “ON” or the engine is
started immediately after engine stop, there
is a case when the entered passcode is not
recorded in the system. At this time, please
try to enter the passcode again.
Entering the passcode