Operation Manual

Bluetooth® 2.0 interface (if so equipped)
5-164 Features and controls
5
 Press this button when an incoming call is
received to answer the telephone.
 When another call is received during a
call, press this button to put the first caller
on hold and talk to the new caller.
• In such circumstances, you can press the
button briefly to switch between callers.
You will switch to the first caller and the
other caller will be put on hold.
• To establish a three-way call in such situ-
ations, press the SPEECH button to enter
voice recognition mode and then say
“Join calls.”
 Press this button when an incoming call is
received to refuse the call.
 Press this button during a call to end the
current call.
When another call is on hold, you will
switch to that call.
 If this button is pressed in the voice recog-
nition mode, the voice recognition mode
will be deactivated.
N00575800025
Your voice will be recognized by a micro-
phone in the overhead console, allowing you
to make hands-free calls with voice com-
mands.
PICK-UP button
NOTE
 On a vehicle equipped with a Mitsubishi
Multi-Communication System, pressing the
PICK-UP button except when an incoming
call is received to answer the telephone will
activate the voice recognition of the Blue-
tooth
®
2.0 interface.
HANG-UP button
NOTE
 When you press the SPEECH button (except
for vehicles with Mitsubishi Multi-Commu-
nication System) or PICK-UP button (for
vehicles with Mitsubishi Multi-Communica-
tion System) to enter voice recognition mode
with a cellular phone paired to the system,
current information on the cellular phone,
such as “remaining battery life,” “signal
strength” or “roaming,” will be displayed on
the audio display.*
*: Some cellular phones will not send this
information to the Bluetooth
®
2.0 interface.
 Call waiting and three-way calls can be used
by the Bluetooth
®
2.0 interface, only if it is
possible to use those services with your cel-
lular phone.
Microphone
NOTE
 If a cellular phone is within close proximity
of the microphone, it may distort the sound
quality. In this case, place the cellular phone
as far as possible from the microphone.