Operation Manual

Hazard warning flasher switch
Features and controls 5-155
5
return to the neutral position when the turn is
complete. There may be times when the lever
does not return to the neutral position. This
usually happens when the steering wheel is
turned only slightly. You can easily return the
lever by hand.
Also, when you move the lever to (1) slightly
then release it, the turn signal lights and indi-
cator light in the instrument cluster will flash
three times.
N00522700217
If you press the flasher switch, the front and
rear turn signals will flash intermittently, and
so will the hazard warning lights. This is an
emergency warning system and should not be
used when the vehicle is in motion, except for
emergencies.
If you need to leave your vehicle, the flashers
will keep working after the ignition key is
removed.
NOTE
 A light in the instrument panel flashes to
show when the front and rear turn signal
lights are working properly.
If this light flashes faster than usual, check
for a burned out light bulb or malfunctioning
connection.
If the panel light does not come on when the
lever is moved, check for a blown fuse or a
burned out bulb in the panel.
Have the vehicle inspected by an authorized
Mitsubishi Motors dealer or a repair facility
of your choice.
 The turn signal light 3-flash function for lane
changes can be deactivated.
See your authorized Mitsubishi Motors
dealer for details.
 You can adjust the time required to operate
the lever for the 3-flash function.
See your authorized Mitsubishi Motors
dealer for details.
Hazard warning flasher
switch
NOTE
 If you keep the flashers on for several hours
with the engine turned off, the battery will
run down.