Operation Manual

Headlight leveling switch (if so equipped)
5-154 Features and controls
5
3. Within 60 seconds of turning the ignition
switch to the “LOCK” position, pull the
turn signal lever toward you.
4. The headlights will come on in the low
beam setting for about 30 seconds. After
the headlights go off, the headlights can
be turned on again in the low beam setting
for about 30 seconds by pulling the turn
signal lever toward you within 60 seconds
of turning the ignition switch to the
“LOCK” position. To turn on the head-
lights again after 60 seconds of turning
the ignition switch to the “LOCK” posi-
tion, repeat the process from step 1.
N00537100088
The direction of the headlight beam (the
direction in which the light shines) alters
according to the number of people and the
load in the vehicle. Lower the headlight angle
if it is too high due to the number of people
and/or the load in the vehicle so that the head-
lights’ glare does not distract the drivers of
approaching vehicles. First set the combina-
tion headlights and dimmer switch to the
“ ” position, then turn the headlight level-
ing switch knob to lower the beam. The
greater the number on the headlight leveling
switch knob, the lower the beam will point.
Set the switch to the appropriate position so
that the headlight beam is level with the road.
N00522601545
When changing lanes, or to making a gradual
turn, hold the lever in the “lane change” posi-
tion (1). It will return to the neutral position
when you let go. Use the full position (2)
when making a normal turn. The lever will
NOTE
 While the coming home light function is
operating, perform one of the following
operations to cancel the function.
• Pull the turn signal lever toward you.
• Turn the combination headlights and dim-
mer switch to the “ ” or “ ” position.
• Turn the ignition switch to the “ON” posi-
tion.
 It is possible to modify functions as follows:
• The time that the headlights remain on can
be changed.
• The coming home light function can be
deactivated.
For details, consult a Mitsubishi Motors
dealer.
Headlight leveling switch (if
so equipped)
NOTE
NOTE
 Start adjusting when the knob is at the “0”
position (when the beam is at its highest).
 Keep the knob in the “0” position except
when using the knob to lower the headlight
beam angle.
 Always return the knob to the “0” position
when the load is removed and the people
have left the vehicle.
Turn signal lever