Operation Manual

Indicators
Features and controls 5-145
5
The rest time can be set.
N00519900127
N00520000216
The arrows will flash in time with the corre-
sponding exterior turn signals when the turn
signal lever is used.
Both arrows will flash when the hazard warn-
ing flasher switch is pressed.
N00520100086
A blue light comes on when the headlights
are on high beam.
N00520200205
This indicator comes on while the front fog
lights are on.
N00551300026
This indicator light illuminates while the
position lights are on.
Screen type 1 Screen type 2 Do this
Park the vehicle in a safe place, turn off the engine, and take a rest.
Use this display as rough guide for taking rests during a long drive.
The interval from the start of your trip until this message is displayed can be set.
Refer to “Changing the function settings (With ignition switch in the “ON” position)” on
page 5-126.
The display and buzzer alert the driver when the set time is reached. If you continue to
drive without having a rest, the buzzer sounds about every 5 minutes to encourage you to
take a rest.
 In the following cases, the time driven is reset and the display returns to the previous
display screen. After this, when the set time is reached again, the display and buzzer
encourage you to take a rest.
• The buzzer sounds 3 times.
• The ignition switch is turned to the “OFF” position.
• The multi-information meter switch is held (for about 2 seconds or more).
Indicators
Turn signal indicators/Hazard
warning lights
NOTE
 If the indicator flashes faster than usual or if
the indicator stays on without flashing, check
for a malfunctioning turn signal light bulb or
turn signal connection.
High beam indicator
Front fog light indicator (if so
equipped)
Position indicator