Operation Manual

Multi-information display
Features and controls 5-131
5
4. Lightly press the multi-information meter
switch to select the amount of time until
the display appears.
5. Press and hold the multi-information
meter switch (for about 2 seconds or
more) to change the setting to the selected
time.
N00563500038
It is possible to change the turn signal sound.
1. Press and hold the multi-information
meter switch for about 2 seconds or more
to switch from the setting mode screen to
the menu screen.
Refer to “Changing the function settings
(With ignition switch in the “ON” posi-
tion)” on page 5-126.
2. Lightly press the multi-information meter
switch to select . (changing the turn
signal sound)
3. Press and hold the multi-information
meter switch for about 2 seconds or more
to switch in sequence from 1 (turn signal
sound 1)  2 (turn signal sound 2)  1
(turn signal sound 1).
The setting changes to the selected turn
signal sound.
N00563600013
It is possible to change the bar graph setting
of the momentary fuel consumption display.
1. Press and hold the multi-information
meter switch for about 2 seconds or more
to switch from the setting mode screen to
the menu screen.
Refer to “Changing the function settings
(With ignition switch in the “ON” posi-
tion)” on page 5-126.
2. Lightly press the multi-information meter
switch to select . (changing the
momentary fuel consumption display)
3. Press and hold the multi-information
meter switch for about 2 seconds or more
to switch in sequence from ON (with the
green bar graph)  OFF (without the
green bar graph)  ON (with the green
bar graph).
The setting changes to the selected bar
graph setting.
NOTE
 If the battery is disconnected, the memory of
the unit setting is erased and is automatically
set to the “OFF”.
 The drive time is reset when the ignition
switch is in the “OFF” position.
Changing the turn signal sound
Changing the momentary fuel con-
sumption display (Type 2)
Type 1
Type 2