Operation Manual

Multi-information display
5-120 Features and controls
5
 When the average speed is being dis-
played, if you hold down the multi-infor-
mation meter switch, the average speed
displayed at that time is reset.
 When the ignition switch is turned to the
“ON” position from the “ACC” or
“LOCK” position, the mode setting
changes automatically from manual to
auto.
Switching to auto occurs automatically. If
switching to manual mode is done, how-
ever, the data from the last reset is dis-
played.
 When the average speed is being dis-
played, if you hold down the multi-infor-
mation meter switch, these calculations
will be reset to zero.
 When the ignition switch has been set to
the “ACC” or “LOCK” position for about
4 hours or more, the average speed dis-
play will automatically reset.
This displays the average fuel consumption
from the last reset to the present.
There are 2 types of mode settings as follows.
For details on how to change the average fuel
consumption display setting, refer to “Chang-
ing the function settings (With ignition switch
in the “ON” position)” on page 5-126.
The “ ” mark in the momentary fuel gauge
shows the average fuel consumption. (Type
2)
 When the average fuel consumption is
being displayed, if you hold down the
multi-information meter switch, the aver-
age fuel consumption displayed at that
time is reset.
 When the ignition switch is turned to the
“ON” position from the “ACC” or
“LOCK” position, the mode setting
changes automatically from manual to
auto.
Switching to auto occurs automatically. If
switching to manual mode is done, how-
ever, the data from the last reset is dis-
played.
 When the average fuel consumption is
being displayed, if you hold down the
multi-information meter switch, these cal-
culations will be reset to zero.
 When the ignition switch has been set to
the “ACC” or “LOCK” position for about
4 hours or more, the average speed dis-
play will automatically reset.
Manual reset mode
Auto reset mode
NOTE
 The average speed display and the average
fuel consumption display can be reset sepa-
rately in both auto reset mode and manual
reset mode.
 “---” is displayed when the average speed
cannot be measured.
 The initial (default) setting is “Auto reset
mode”.
 The display setting can be changed to the
preferred units (mph or km/h).
Refer to “Changing the function settings
(With ignition switch in the “ON” position)”
on page 5-126.
 The average speed display memories for auto
reset mode and manual reset mode are erased
if the battery is disconnected.
Average fuel consumption display
NOTE
Manual reset mode
Auto reset mode