Operation Manual

Multi-information display
Features and controls 5-119
5
The operation method is the same as when
the ignition switch is in the “OFF” position.
For further details, refer to “Odometer/Trip
odometer” on page 5-114.
Shows the distance and number of months
until the next periodic inspection.
Refer to “Service reminder” on page 5-123.
Shows the engine coolant temperature.
If the coolant becomes hot, “ ” will blink.
Pay careful attention to the engine coolant
temperature display while you are driving.
Shows the approximate driving range (how
many more miles or kilometers you can
drive) with the current fuel level. When this
driving range falls below 30 miles (50 km), “-
--” is displayed.
Refuel as soon as possible.
This displays the average speed from the last
reset to the present.
There are 2 types of mode settings as follows.
For details on how to change the average
speed display setting, refer to “Changing the
function settings (With ignition switch in the
“ON” position)” on page 5-126.
8- Average fuel consumption display,
momentary fuel consumption display
(Type 2)
9- Average speed display, momentary fuel
consumption display (Type 2)
10- Function setting screen
11- Redisplay of a warning display screen
NOTE
 While driving, the function setting screen is
not displayed even if you operate the multi-
information meter switch. Always park the
vehicle in a safe place before operating.
Refer to “Changing the function settings
(With ignition switch in the “ON” position)”
on page 5-126.
 When there is information to be announced,
such as a system fault, the tone sounds and
the screen display is changed.
Refer to “Interrupt display screen (With igni-
tion switch in the “ON” position)” on page
5-121.
Odometer/Trip odometer
Service reminder
Engine coolant temperature dis-
play
CAUTION
 If the engine is overheating, “ ” will blink.
In this case, the bar graph is on the red zone.
Immediately park the vehicle in a safe place
and take the required measures. Refer to
“Engine overheating” on page 8-4.
Driving range display
NOTE
 The driving range is determined based on the
fuel consumption data. This may vary
depending on the driving conditions and hab-
its. Treat the distance displayed as just a
rough guideline.
 When you refuel, the driving range display is
automatically updated.
However, if you only add a small amount of
fuel, the correct value will not be displayed.
Fill to a full tank whenever possible.
 When your vehicle is stopped on an
extremely steep hill, the driving range value
may change. This is due to the movement of
fuel in the tank and does not indicate any
problem.
 The display setting can be changed to the
preferred units (miles or km).
Refer to “Changing the function settings
(With ignition switch in the “ON” position)”
on page 5-126.
Average speed display