Operation Manual

Rear-view camera (if so equipped)
5-108 Features and controls
5
N00532900179
If new wheels with new tire inflation pressure
sensors are installed, their ID codes must be
programmed into the tire pressure monitoring
system. Have tire and wheel replacement per-
formed by an authorized Mitsubishi Motors
dealer to avoid the risk of damaging the tire
inflation pressure sensors. If the wheel
replacement is not done by an authorized
Mitsubishi Motors dealer, it is not covered by
your warranty.
N00533001259
Your tire pressure monitoring system oper-
ates on a radio frequency subject to Federal
Communications Commission (FCC) Rules
(For vehicles sold in U.S.A.) and Industry
Canada Rules (For vehicles sold in Canada).
This device complies with Part 15 of FCC
Rules and Industry Canada licence-exempt
RSS standard(s).
Operation is subject to the following two con-
ditions.
 This device may not cause harmful inter-
ference.
 This device must accept any interference
received, including interference that may
cause undesired operation.
N00546201154
When the gearshift lever or the selector lever
is in the “R” (REVERSE) position with the
ignition switch in the “ON” position, the rear-
view image will be displayed on the screen of
the Mitsubishi Multi-Communication Sys-
tem or the DISPLAY AUDIO in the center
panel.
When the gearshift lever or the selector lever
is shifted out of the “R” (REVERSE) posi-
tion, the rear-view image will go off.
The rear-view camera (A) is built-in to the
trunk lid.
Whenever the tires and wheels
are replaced with new ones
CAUTION
 The use of non-genuine wheels will prevent
the proper fit of the tire inflation pressure
sensors, resulting in air leakage or damage to
the sensors.
General information
CAUTION
 Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user’s authority to oper-
ate the equipment.
Rear-view camera (if so
equipped)
WARNING
 Never rely solely on the rear-view camera
to clear the area behind your vehicle.
Always check visually behind and all
around your vehicle for persons, animals,
obstructions or other vehicles. Failure to
do so can result in vehicle damage, serious
injury or death.
 The rear-view camera is an aid system for
backing up, but it is not a substitute for
your visual confirmation.
 The view on the screen is limited, and
objects outside the view, such as under the
bumper or around either corner of the
bumper end, cannot be seen on the screen.
Location of rear-view camera
A