Operation Manual

Theft-alarm system
Features and controls 5-43
5
provides both audible and visual alarm sig-
nals.
N00510301183
Park the vehicle and stop the engine. Arm the
system as described below.
1. Turn the ignition switch to the “LOCK”
position.
Also, if a key was used to start the engine,
remove the key from the ignition switch.
2. Make sure that the trunk lid and engine
hood are closed.
3. Lock all doors by either the remote con-
trol transmitter or the F.A.S.T.-key.
At this time, the theft-alarm indicator (A)
on the audio panel flashes for confirma-
tion.
4. The system has entered the armed stage
after about 20 seconds, when the theft-
alarm indicator (A) flashing becomes
slower.
The theft-alarm indicator (A) continues to
flash while the system is in the armed
stage.
N00510401197
The alarm will be activated if any of the fol-
lowing occur while the vehicle is parked and
the system is armed.
CAUTION
 Do not modify or add parts to the theft-alarm
system. Doing so could cause the theft-alarm
to malfunction.
Armed stage
Arm the system and leave
NOTE
 If the engine hood or the trunk lid is open,
the theft-alarm indicator (A) illuminates and
the system cannot enter the armed stage. The
system enters the armed stage about 20 sec-
onds after the engine hood or the trunk lid is
closed.
 The system will be disarmed if, while the
theft-alarm indicator (A) is illuminated, all
doors are unlocked by remote control trans-
mitter or the F.A.S.T.-key.
 The system will be disarmed if, while the
theft-alarm indicator is illuminated, the igni-
tion switch is turned to the “ON” position.
 The system will not be armed if a door or the
trunk lid or the engine hood is not com-
pletely closed. If this happens, rearm the sys-
tem as described above.
Alarm stage