Operating instructions

Possible Solution
° The TV remote control does not work. • Check that the batteries are installed correctly.
° Check that the selected switch is set to "TV".
• Be no f'urther than 20 {_et from the TV when using the remote control.
° Avoid using under or near strong fluorescent llghtlng.
" On-screen dlsplays appear each time you change a fimctlon. " This is part of normal TV operation.
• There is no sound even when the volume is turned llp. • Check to see if the MUTE button is on.
• Check that "TV Speakers" setting is Om
" Power is suddenly turned off " Check SLEEP TIMER and PC Power Save settings.
° The sound does not match the screen picture. * ]fusing stereo or A/V revelver speakers, check input selection on the
stereo or A/V receiver.
° q!fusing stereo or A/V receiver, check that AT{JD]O is fi'om AU[)IO
OUT on TV's side panel.
° Picture is out of_'ocus, or colors are not allgned. ° Check tile Sharpness, ColorView, and input signal settings (page 50).
° You cannot see a picture when ynu play a VCR tape. ° If you connected ynur VCR with A/V cables, use the DEVICE button
to select the Input source (]NPUT) that the VCR is connected to.
• Checkyour VCRs owner's guide }'orthrther troubleshooting.
• Cannot set a@lstments to f_tctory setting • Follow the steps below to reset system def_mlts to f_tctory settings.
I. Press the TV MENU button fbllowed b_ mlmber buttons 1,2,alld 3 on
the remote control.
Result: The above steps activate tile Reset System Defimlts metro screen
2. Press the ENTER button on the remote control.
Result : Tile settings reset to factor) defimlts.
3. Press the HOME or TV MENU button on the remote control to
return to the HOME or TV MENU screeen.
IMPORTANT: This {'onctlonis not recommended unless it is mandatory
to reset s?stem def;:mltsto factor!, setthlgs. This operation CANNOT be
undone md all customs settings will be erased.