Operating instructions

Stand Alone Configuration Setup
1. Place the 42" LCD Display on a sturdy surfhce.
2. Remove the HD-6000 Receiver/Controller from its carton.
3. Place the HD-6000 Receiver/Controller on a sturdy surface.
4. Connect the HDMY _MCable from the HDMP "MOutput connector on the back of the HD-6000 to
the HDMP'MiMonitorLink 'rM_[NPUT connector located on the back of the LCD Display:
HDo6000 Back Panel (section detail)
®®
_®,® .....2::2::::
LCD Display Back Panel (section detail)
5. Connect the USB Cable fi:om the Authorized Card Reader connector on the back of the HD-6000 to
the AUTHORIZED CARD READER connector on the back of the LCD Display.
HD-6000 Back Panel (section detail)
LCD Display Back Panel (section detail)
6. Cormect the RS-232C Cable from the MonimrLink' Control RS-232C connector on the back
FM
of the HD-6000 to the RS-232CiMonitorLink' Control for HD-6000 connector on the back of the
LCD Display:
HD-6000 Back Panel (section detail) LCD Display Back Panel (section detail)
@@÷@@@@ ®@e
@@@@@ @@@