Operation Manual

MiEV Remote System
General information/Charging 3-39
3
5. Press the power/communication switch
(B) for less than 1 second to send the set-
ting data to the vehicle.
The MiEV Remote will sound melodies
on transmission and reception.
6. To turn off the MiEV Remote, refer to
“To turn the MiEV Remote ON/OFF” on
page 3-38.
N01206000014
1. Turn on the MiEV Remote. Refer to “To
turn the MiEV Remote ON/OFF” on page
3-38.
NOTE
 The melodies can be turned off. Refer to “To
turn on/off melody and buzzer” on page
3-45.
 If a communication error occurs or the MiEV
Remote System is not functioning properly,
the buzzer will sound. Refer to “Display of
MiEV Remote during communicating with
vehicle” on page 3-41.
 If the OFF Timer is unset when setting the
ON timer, the OFF timer will be automati-
cally set with “fully charged”.
 To set OFF Timer, refer to “To set OFF
Timer” on page 3-40.
NOTE
 The energy level gauge (E) in the instrument
panel on the vehicle will illuminate and the
charging indicator (F) will blink approxi-
mately 30 seconds after the vehicle has
received the setting for the ON timer.
After approximately 30 seconds, the energy
level gauge and the charging indicator will
go off, and the vehicle will be prepared for
the Charging Timer.
 Turning the electric motor switch to the
“ON” position or the “ACC” position will
cancel the Charging Timer.
E
F
 If the MODE switch is pressed while chang-
ing the ON timer setting, the change will be
canceled.
 The symbol on the MiEV Remote
will be illuminated while the vehicle is
charging.
 If the charge connector is disconnected
before the time set by the ON timer, the
Charging Timer is not canceled. If the charge
connector is re-connected again before start-
ing the charge or setting the charge timers,
the Charging Timer will resume.
To start the charging immediately
after the ON timer has been set
NOTE
BK0209800US.book 39 ページ ２０１４年１月１４日 火曜日 午前９時２６分