Operation Manual

Regular charging (charging method with rated AC 120 V outlet)
General information/Charging 3-19
3
10. Make sure that the charging indicator on
the instrument cluster is illuminated.
If the charging indicator is not illumi-
nated, charging will not start.
Make sure that the regular charge port, the
plug and the connector are correctly con-
nected, and perform charging from Step 5
again.
11. Charging is complete when the charging
indicator turns off. Pull out the regular
charge connector while pressing the but-
ton (M).
12. Close the inner lid and close the regular
charging lid.
13. Remove the charging cable plug from the
outlet.
NOTE
 When the regular charge connector is con-
nected to the charge port, the charging indi-
cator is blinking. When charging is started,
the charging indicator is illuminated.
 The charge level for main drive lithium-ion
battery can be checked with the energy level
gauge (L) on the instrument cluster.
Refer to “Energy level gauge” on page 5-40.
NOTE
L
M
WARNING
 After charging, disconnect the charge con-
nector completely from the charge port. If
the charge connector remains partially
engaged with the latch unlocked, the elec-
tric motor switch can be turned to the
“START” position and the vehicle can be
moved.
NOTE
 Charging can be stopped half way. In this
case, pull out the regular charge connector
while pressing the button.
NOTE
 Make sure that the inner lid is completely
closed before closing the regular charging
lid.
If the regular charging lid is forcibly closed
without completely closing the inner lid, the
hinge on the inner lid may be broken.
BK0209800US.book 19 ページ ２０１４年１月１４日 火曜日 午前９時２６分