Operation Manual

Replacement of light bulbs
Vehicle care and maintenance 9-25
9
3. Turn the socket counterclockwise to
remove it.
4. Remove the bulb as follows.
[Front turn signal light]
Pull the bulb out of the socket.
[Front fog light and daytime running
light]
While holding down the tab (G), pull out
the bulb assembly (H).
5. To install the bulb, perform the removal
steps in reverse.
N00943700487
1. Open the liftgate.
(Refer to “Liftgate” on page 5-11.)
D- Front turn signal light
E- Front fog light
F- Daytime running light
Front turn signal light
Front fog light
Daytime running light
CAUTION
 Handle halogen light bulb with care. The gas
inside a halogen light bulb is highly pressur-
ized, so dropping, knocking, or scratching a
halogen light bulb can cause it to shatter.
 Never hold the halogen light bulb with a bare
hand, dirty glove, etc.
The oil from your hand could cause the bulb
to break the next time the fog lights are used.
If the glass surface is dirty, clean it with
alcohol and let it dry completely before
installing the bulb.
Rear combination lights
BK0209800US.book 25 ページ ２０１４年１月１４日 火曜日 午前９時２６分