Operation Manual

Tire repair kit
For emergencies 8-9
8
11. Holding the sealant bottle upside-down,
squeeze it again and again to inject all of
the sealant into the tire.
12. After injecting the sealant, pull the hose
off the valve, remove any residual sealant
from the valve, rim and/or tire.
Fit the valve insert (K) into the valve (I),
and screw the valve insert securely into
place using the valve remover (J).
13. Pull out the compressor hose (N) from the
side of the tire compressor, and then
securely attach the hose to the tire valve
(I).
14. Place the compressor (O) with its air pres-
sure gauge (P) on top.
Pull out the compressor’s power cord (Q),
insert the plug on the cord into the 12 V
power outlet (R), and then turn the elec-
tric motor switch to the “ACC” position.
(Refer to “12V power outlet” on page
5-51.)
Turn ON the compressor switch (S) and
inflate the tire to the specified pressure.
(Refer to “Tire inflation pressures” on
page 9-13.)
If there is a gap between the tire and
wheel, push the tread area toward the cen-
ter of the wheel to close the gap before
running the compressor.
BK0209800US.book 9 ページ ２０１４年１月１４日 火曜日 午前９時２６分