Operation Manual

Tire repair kit
8-8 For emergencies
8
7. Take the cap (D) off the tire sealant bottle
(E). Do not remove the seal (F). Screw the
filler hose (G) onto the bottle (E). As you
screw the filler hose onto the bottle, the
seal will break, allowing the sealant to be
used.
8. Take the valve cap (H) off the tire valve
(I), then press the valve remover (J) onto
the valve as illustrated. Allow all of the
air in the tire to escape.
9. Remove the valve insert (K) by turning it
counterclockwise using the valve remover
(J). Put the removed valve insert in a
clean place so it does not get dirty.
10. Remove the plug (L) from the free end of
the hose (M). Press the hose onto the
valve (I).
CAUTION
 If you shake the bottle after screwing on the
hose, sealant may spray out of the hose.
WARNING
 If there is any air left in the tire when you
remove the valve insert, the valve insert
may fly out and injure you. Make sure the
tire contains no air before removing the
valve insert.
NOTE
 Turn the valve remover by hand. If you use a
tool, the valve remover could be damaged.
BK0209800US.book 8 ページ ２０１４年１月１４日 火曜日 午前９時２６分