Operation Manual

Power window control
5-14 Features and controls
5
 All doors and the liftgate are unlocked by
using the keyless entry system.
Use the following procedure to test the sys-
tem:
1. Lower the driver’s window.
2. Arm the system as explained in “Armed
stage”.
3. Make sure that the theft-alarm indicator
comes on and flashes for approximately
20 seconds.
4. Wait a few seconds and then unlock the
driver’s side door by using the inside door
lock knob. Open the door.
5. Make sure that the horn sounds intermit-
tently and the headlights blink when a
door is opened.
6. Disarm the system by unlocking all doors
and the liftgate by using the keyless entry
system.
N00510800396
NOTE
 If the UNLOCK button on the remote control
transmitter is operated when all doors and
the liftgate are closed and no door is opened
within approximately 30 seconds, re-arming
will automatically occur.
 The amount of time after unlocking until the
vehicle relocks automatically can be
adjusted. See a certified i-MiEV dealer for
details.
 Once the system has been disarmed, it can-
not be rearmed except by repeating the arm-
ing procedure.
Testing the theft-alarm system
Disarm...by using the keyless entry system
Power window control
1- Open (down)
2- Close (up)
NOTE
 Never try to operate the main switch and
sub-switch in different directions at the same
time. This will freeze the window in posi-
tion.
 Operating the power windows repeatedly
with the electric motor unit stopped will run
down the 12V starter battery. Use the win-
dow switches only while the electric motor
unit is operating.
WARNING
 Before operating the power windows,
make sure that nothing can be trapped
(head, hands, fingers, etc.) in the window.
 Never leave the vehicle without carrying
the key.
 Never leave children or unreliable adults
unattended inside the vehicle.
BK0209800US.book 14 ページ ２０１４年１月１４日 火曜日 午前９時２６分