Manual

• Program to record
Channel 2
Day Monday 19
Start time 11:30A_
Record speed AUTO
Select with O.K.PROGRAM,
then pause for 4 seconds
O Press the ONE KEY PROGRAM button to choose the hour
you wish recording to stop. Then, wait fi)r 4 seconds. The
minute numbers will begin to flash.
• Program to record
Channel 2
Day Monday 19
Start time II:30A_
_ I:30PM
Record speed AUTO
Select with O.K.PROGRAM,
then pause for 4 seconds
O Press the ONE KEY PROGRAM button to choose the: minute
you wish recording to stop. Then, wait for 4 seconds. The
record speed will flash.
• Program to record
Channel 2
[lay Monday 19
Start time II:30A.
Stop time 1:30P.
_ sP
Select with O.K.PROGRAM,
then pause for 4 seconds
_Important:
@) Press the ONE KEY PROGRAM button to set the recording
speed. After 4 seconds, tlhe menus will turn off.
@
When you are finished with al] programming, turn the VCR
power OFF and :make sure the programmed recording light
(33) is lit. However, if you have a cable box, leave it turned
ON. Additionally, if the HS-U560, does not control your cable
box, leave the box tuned to the station you wish to record.
The VCR is ready to record what you've pro___ammed. If you "want
to exit One Key Programming, press STOP.
changingsettingswhileprogramming
If you make a mistake when using One Key Program:
@
Turn the shuttle ring on the front panel to move the cursor to
the setting you wish to change. Turning the ring right will
move you forward, while turning the rint,_ left will move you
backward. If you wish to use the remol;e control, you can use
ENTER to move fbrward or CANCEL to move backward.
Once you have chosen a setting, you can change it by using
the JOG dial on the front panel, or the ADJUST dial on tlhe
remote control.
@) Once you have corrected the setting, turn the shuttle ring
right, or press ENTER on the remote cot trol to resume your
place.
If you press CANCEL or turn the shuttle ring left while the
cursor is next to the ,channel number, you will cancel the entire
program. If you want to stop using the One Key Program, press
the stop button.
47