Operation Manual
EN-50
Replacing the lamp (continued)
4. Insert two lugs of the lamp replacement attachment
into the slits (h) in the projector and fix the three
taping portions (g) with the tape included in the
lamp replacement attachment.
(h)
(g)
5. Pull out the lamp unit (f) in the bag by the handle
(e).
(f)
(e)
6. Remove the tape fixing the lamp replacement
attachment, and remove the lamp replacement
attachment with the lamp unit remaining in the bag.
Caution:
t 1VMMUIFMBNQVOJUPVUPGUIFQSPKFDUPSTMPXMZ
If it is pulled out quickly, the lamp may break,
scattering glass fragments.
t %POPUTQJMMMJRVJEPOUIFSFNPWFEMBNQVOJUPS
do not place it near any flammable object or
where children can reach to prevent injuries or
fire.
7. Insert the new lamp unit, and secure it with two
screws firmly.
8. Secure the lamp cover with screw (b) back again,
and mount the cover (a).
Caution:
t
Make sure that the lamp cover is secured firmly.
Otherwise, the POWER indicator flashes red and
green, disallowing the projector to be powered on.
Reset of the lamp operation time
Plug in the power cord, and reset the lamp operation
time by keep pressing the , , and POWER buttons
on the control panel at the same time.
Important:
t 6OMFTTUIFTFUISFFCVUUPOTBSFQSFTTFEBUUIFTBNF
time, the lamp operation time isn’t reset.
t .BLFTVSFUIBUUIF45"564JOEJDBUPSJTMJUUXJDFBOE
the lamp operation time is reset successfully.
t 5IFQSPKFDUPSEPFTOUUVSOPOJGUIFMBNQDPWFSJTOU
attached securely.
t #FTVSFUPSFTFUUIFMBNQPQFSBUJPOUJNFXIFOFWFS
you replace the lamp.
t %POPUSFTFUUIFMBNQPQFSBUJPOUJNFVOMFTTZPV
replace the lamp.
t 5IFMBNQJTGSBHJMF*GJUJTCSPLFOCFDBSFGVMOPUUP
cut yourself with glass fragments.
Caution:
t
This projector uses a lamp that
contains mercury. Disposal of the lamp
or the projector with the lamp may
be regulated due to environmental
considerations. For disposal or
recycling information, please contact
your local authorities or the Electronic
Industries Alliance: www.eiae.org. (For
the U.S. only.)