User`s manual
Table Of Contents
- SAFETY PRECAUTIONS
- CONDITIONS OF USE FOR THE PRODUCT
- REVISIONS
- INTRODUCTION
- CONTENTS
- ABOUT MANUALS
- HOW TO USE THIS MANUAL
- ABOUT THE GENERIC TERMS AND ABBREVIATIONS
- PACKING LIST
- 1. OVERVIEW
- 2. SYSTEM CONFIGURATION
- 3. FUNCTION LIST
- 4. INSTALLATION AND UNINSTALLATION
- 5. SCREEN MAKEUP AND BASIC OPERATIONS
- 6. PROJECT CREATION
- 7. SYSTEM CHECKING FROM PERIPHERAL DEVICE
- 8. DATA SETTING
- 9. WRITING TO/READING OF/VERIFICATION OF POSITIONING MODULE DATA
- 10. POSITIONING DEBUGGING
- 11. USEFUL FUNCTIONS
- APPENDIX
- Appendix 1 Read from Module/Write to Module Reference Processing Times
- Appendix 2 Restrictions Depending on Function Version of QD75
- Appendix 3 Functions Added to/Changed from the Previous Versions
- Appendix 4 Uninstalling the License Key FD
- Appendix 5 Parameter Names Shown in GX Configurator-QP Screens and Manuals
- INDEX
6 - 12 6 - 12
MELSOFT
6. PROJECT CREATION
• Since there are no four-axis type AD75 positioning modules, the positioning data,
block start data and parameters of the fourth axis are not read if the QD75 model
of the save destination project is of the four axis type.
• Note the following when the file in the GX Configurator-AP or SW1
-AD75P
format has been read to GX Configurator-QP.
[AD75P
QD75P/QD75D]
Data Type Read to GX Configurator-QP
Start bias speed
Section is changed from basic parameter 2 to basic
parameter 1.
Over limit
Under limit
Drive unit ready
Stop signal
External signal
Zero phase signal
Zeroing dog
MPG
DCC
These are new items and therefore not read.
Default setting.
I/O logic
Command PLS signal
Output pulse logic selection to drive unit has been
changed to this name.
Stepping motor mode
Manual pulse generator selection
ACC/DEC time unit selection
These are disused items and therefore read-
disabled.
Near path control mode selection
This is a disused item and therefore read-disabled.
(Because near path control mode is fixed)
Manual pulse generator input
selection
Parameter
Speed-position function selection
These are new items and therefore read-disabled.
Default setting.
SLV axis
This is a new item and therefore read-disabled.
Default setting.
Positioning
data
Positioning comment Not read from SW1
-AD75P.
Block start data
Start block data has been changed to this name.
Because of reduction in number of blocks, block
numbers 5 to 10 are read-disabled.
"Stop" in special start is replaced by "Wait start".
Indirect data This is a disused item and therefore read-disabled.
: After file reading, condition data setting is needed.
[AD75P QD75M/QD75MH, AD75M QD75P/QD75D]
Data Type Read to GX Configurator-QP
Parameter
Servo parameter
Default setting since parameter data differ.
SLV axis
This is a new item and therefore read-disabled.
Default setting.
Positioning
data
Positioning comment Not read from SW1
-AD75P.
Block start data
Start block data has been changed to this name.
Because of reduction in number of blocks, block
numbers 5 to 10 are read-disabled.
"Stop" in special start is replaced by "Wait start".
Indirect data This is a disused item and therefore read-disabled.
: After file reading, condition data setting is needed.