User`s manual

Index - 4 Index - 4
product
information .............................................. 11- 41
makeup ...................................................... A-12
product ID ....................................................... 4- 5
Programmable controller
corresponding ............................................. 1- 1
storing buffer memory values into............ 11- 5
type of ......................................................... 7- 2
project
active........................................................... 5- 2
makeup ....................................................... 6- 1
project path change........................................ 6- 4
project tree view ............................................. 5- 1
[Q]
Q corresponding MELSECNET/H network
remote I/O module.......... 1- 1, 2- 2, 7- 1, 9- 1
Q corresponding serial communication
module .................................1- 1, 2- 1, 7- 2, 5
QD75/LD75/LD77 READY signal (X0) ....... 11-24
[R]
radio button..................................................... 5- 3
read
from HD/FD................................................. 6- 6
from positioning module ........................... 10- 1
from SW0D5C-AD75P format file ............. 6-11
from SW1RX/IVD/NX-AD75P format file .. 6-11
of trace data....................................... 11-36, 41
remote I/O....................................................... 7- 1
right-click menu .......... 5- 2, 8- 2, 10-28, 11-11,12
row clear ...................................................... 11-17
RS-232C cable ....................................... 2- 1, 7- 2
[S]
sampling monitor ......................................... 10-25
save
data in flash ROM of positioning module... 9- 6
of auto refresh setting............................... 11- 9
of project ..................................................... 6- 8
of trace data....................................... 11-36, 41
save as ........................................................... 6- 8
Select all ...................................................... 11-13
servo amplifier data read ............................... 9- 6
servo monitor ...............................................10-19
servo On/Off.................................................10-42
servo parameter setting..................................8- 3
setting
of block start data.......................................8-16
of condition data .........................................8-18
of M code comment ...................................8-12
of parameters ..............................................8- 1
of positioning data .......................................8- 3
of print range ............................................11-28
of printer ...................................................11-24
of selection range in batch.......................11-12
option ........................................................11-23
shortcut key.....................................................5- 4
signal monitor................................................10- 8
single-module test........................................10-30
software registration card ...............................4- 6
specifying access target .................................7- 1
speed
automatic setting of ....................................8-10
monitoring......................................10- 5, 15, 16
speed change test .......................................10-36
spin box ...........................................................5- 3
spreadsheet software data
copying from.............................................11-12
reading........................................................6-14
writing to .....................................................6-16
SSCNET
(Servo System Controller NETwork) .....8- 3
start
of application ..............................................4-31
of monitor...................................10- 4, 5, 25, 27
of test ........................................................10-30
status bar.........................................................5- 1
status signal monitor....................................10-12
stop................................................................10- 1
switching
of block to be edited .......................... 5- 1, 8-17
of window.....................................................5- 4
system configuration.......................................2- 1
system monitor................................................7- 8