User`s manual

Index - 1 Index - 1
INDEX
[2]
2-axis interpolation control
assisting the setting of ................................ 8- 9
simulation of............................................... 8-13
trace of ..................................................... 11-38
[A]
Active project .................5- 2, 6- 8, 15, 16, 9- 2, 6,
10-30, 11-1, 3, 5, 17, 26
All axis stop .................................................. 10- 1
application
ending ........................................................ 4-32
starting ....................................................... 4-31
assistance
of axis speed setting.................................. 8-10
of circular interpolation control setting ....... 8- 9
of software operation............................... 11-45
automatically
setting axis speed..................................... 8- 10
storing buffer memory values................... 11- 5
Axis #1 to #4
error reset of .............................. 7-10, 12, 10- 1
turning off the M code ON signal of ......... 10- 1
axis control monitor ..................................... 10-13
axis copy...................................................... 11-18
axis status............................................. 7- 8, 10- 5
[B]
batch write .................................................... 11- 9
block
copy.......................................................... 11-19
switching ............................................ 5- 1, 8-19
block start data
error (project) ............................................. 8-20
error (module) ........................................... 10- 2
initialization .............................................. 11-17
setting......................................................... 8-18
buffer memory
assigning to devices ................................. 11- 7
list ............................................................. 11-43
[C]
cable ........................................................2- 7, 7- 4
cableless test ...............................................10-30
check box ........................................................5- 3
column clear.................................................11-16
COM port setting.............................................7- 1
command button .............................................5- 3
comment
M code........................................................8-12
positioning data ...........................................8- 8
condition
of special start ............................................8-16
of trace start .......................................11-36, 41
condition data...........................................8-18, 19
connection setup.............................................7- 1
copy
of block start data.....................................11-19
of selection range.....................................11-11
on axis basis.............................................11-18
CSV format positioning data file
reading of....................................................6-15
writing of .....................................................6-16
cut.................................................................11-11
[D]
data initialization...........................................11-17
Deleting the project ........................................6-10
display
of status bar.................................................5- 1
of toolbar......................................................5- 1
drop-down menu .............................................5- 1
[E]
end
of application ..............................................4-32
of monitor...............................................10- 4, 5
of test ........................................................10-30
entering present value to address...............11-32
error
check (module)..........................................10- 2
check (project)............................................8-20
code list ....................................................11-43
monitoring code.........................................10- 5
monitoring the history of............................10- 7
resetting of................................. 7-10, 12, 10- 1
I