User`s manual

Appendix - 5 Appendix - 5
MELSOFT
A
PPENDICES
Appendix 5 Parameter Names Shown in GX Configurator-QP Screens and Manuals
Since the parameter names of the existing software are employed for GX Configurator-
QP, some parameter names shown in GX Configurator-QP screens may differ from
those written in the user’s manual for the positioning module used.
The following table lists parameter names shown in GX Configurator-QP screens and
user’s manual for the positioning module used.
GX Configurator-QP screen
User's manual for the positioning module used
Parameter type Parameter name Parameter type Parameter name
Unit Unit setting
Pulse per rotation No. of pulses per rotation
Travel per rotation Movement amount per rotation
Unit magnification Unit magnification
Pulse output mode Pulse output mode
Rotation direction Rotation direction setting
Basic parameter 1
Bias speed at start
Basic parameters 1
Bias speed at start
Speed limit Speed limit value
ACC time #0 Acceleration time 0
Basic parameter 2
DEC time #0
Basic parameters 2
Deceleration time 0
Backlash compensation Backlash compensation amount
S/W stroke LMT HIGH
Software stroke limit upper limit
value
S/W stroke LMT LOW
Software stroke limit lower limit
value
S/W stroke LMT select Software stroke limit selection
JOG&MPG stroke limit
Software stroke limit valid/invalid
setting
Command in-position Command in-position width
Torque limit Torque limit setting value
M code ON output M code ON signal output timing
Speed switching mode Speed switching mode
Interpolation speed mode
Interpolation speed designation
method
Address update in V-control
Current feed value during speed
control
Lower limit
Input signal logic selection:
Lower limit
Upper limit
Input signal logic selection:
Upper limit
Drive unit READY
Input signal logic selection:
Drive unit READY
Stop signal
Input signal logic selection:
Stop signal
Extended
parameter 1
External command
Detailed
parameters 1
Input signal logic selection:
External command