User`s manual

11 - 4 11 - 4
MELSOFT
11. USEFUL FUNCTIONS
DISPLAY/SETTING DATA
Item Description
Select type Choose the model (type with the exception of the axis number) of the QD75.
Select Axis Choose the number of axes of the QD75.
"OK" button Click this button to change the model.
• Note that the model of MELSEC-Q series positioning module cannot be changed
to that of MELSEC-L series.
• Independent of the QD75 model selected for the project, all data that can be set in
the edit mode are saved in the project.
In a new project whose number of axes is 1, the parameters, positioning data,
block start data, etc. of undisplayed Axis 2 to Axis 4 are saved. (However, the data
of Axis 2 to Axis 4 are initial values.)
When the project whose number of axes is 4 is saved after changing to a model
for 1 or 2 axes, the data of Axis 3/Axis 4 is saved unchanged.
Therefore, the model can be changed without restriction on the model selected
when a new project is created.
• Depending on the combination of QD75 models, data may not be converted as
shown in the following table.
Conversion destination
Conversion
source
QD75P QD75D QD75M QD75MH
QD75P
QD75D
QD75M
QD75MH
: Conversion available
: Conversion is available for positioning data and block start data only.
As default values are set to parameters and servo parameters resetting is
required.
: Conversion is available for positioning data, block start data and parameter
only. As default values are set to servo parameters, resetting is required.