Specifications

91 GX Configurator-DP

client computer. The

Write to PLC

button uploads the selected configuration project to the web

server where it is written to the PLC.

Note:

By downloading a configuration you stop the data exchange on the DP network.

If the configuration download is successful, the following web page appears:

Update Autorefresh in CPU:

Only available for Q series, and only if the CPU is stopped. If selected, the autorefresh settings in

the IPARAM file of the CPU are updated immediately after successfully writing the configuration

project to the PLC.

If an autorefresh entry for this slot is already present in the IPARAM file, it is overwritten with the

settings matching the module configuration. If no IPARAM file is found, it is created. If no entry for

this slot can be found, it is inserted at the appropriate position in the file.

CPU Mode

Displays the current CPU mode. The desired CPU mode can be selected from the drop down list

and set via the <Set> button.

Data Transfer

Manually starts or stops the PROFIBUS DP data transfer for the displayed DP master.

Note:

If you manually start the PROFIBUS DP data transfer, the data transfer will stop after a

reset or after turning on the power supply of the PLC. The PROFIBUS DP data transfer

must be started explicitly by an extra program that sets the startup request signal at the

respective address of the DP master (Y0 + offset: start request signal).

Current Autorefresh Settings

Open the Auto Refresh Settings page. On this page the autorefresh entries in the IPARAM file are

read from the connected PLC CPU, parsed and displayed in a table (see below).