Specifications

90Web-Based Online Access

Mode

Displays the current operating mode of the module. The desired operating mode can be selected

from the drop down list and set via the Set button.

Note:

The current FDL address cannot be displayed for the A(1S)J71PB92D.

If you use a A(1S)J71PB92D module the user must set the correct mode with the switch

on the front of the module. The modes are 0 or E for operation mode and 1 for

configuration mode. The module will take over the setting of the mode switch after a CPU

reset.

The mode of a FX3U-64DP-M will not be displayed and also cannot be changed. This

master module supports only one operation mode.

For redundant systems:

Note:

Only the mode of that master module is changed, which is located in the PLC rack

connected to the PC. The second QnPRH system is not accessed via the tracking

cable. If you want to change the mode of both master modules, you must therefore

connect to both modules one after the other.

Depending on the mode of the redundant system, certain restrictions apply:

Debug mode

: the mode of the master modules in both PLC racks can be changed

Separate mode

: device tracking must be turned off, before changes to the

standby master are possible

Backup mode

: the redundant system must first be switched to separate mode

and device tracking must be turned off, before changes to the standby master are

possible

Project

To configure the DP master a configuration project (*.dp2) created by GX Configurator-DP is

required. The Browse button opens a file dialog to browse for such a configuration project on the