Specifications

79 GX Configurator-DP

The symbolic name for the transfer setup has changed and can be selected from the

Transfer

Setup Names

drop-down list.

Command Test

The configured transfer setup can be tested online. When the <Test> button is clicked, a

connection to the master module is initiated in two steps using the configured communication

interfaces and parameters

1. connect to the target PLC

2. connect to the master module within the target PLC with the specified slot

If no module of the type selected in the project is found in the specified slot, a list of the modules

found in the target PLC rack is displayed, so the user can determine the slot number of the master

module and correct it.

If you click on the <Test> button and the connection to the PLC can be established, a message is

displayed.

The type may differ from the CPU type, which the user has set in the selected transfer setup. As

long as the connected CPU belongs to the selected 'PLC Series', the exact CPU type is

automatically detected.

Failing of a PLC CPU connection leads to a warning message.

In that case check the transfer setup settings and the cable connection between PC and PLC.