Specifications

76Transfer Setup

Security note

Test the selected network configuration by clicking on the button Connection test. If the

connection between the PC and the network is possible a positive note will be shown on the

screen. If no connection is possible an error message is shown. In this case you have to check

the cabling as well as the connection parameters set in the transfer setup and, if used, the

respective PLC network modules.

Close the dialog by clicking on OK. The selected network configuration will be saved and shown

in the Transfer Setup.

Dialog

Transfer Setup

Now click on System image. An information window is opened in which an image of the setup

system is shown.

In comparison to the Connection channel list dialog in this dialog the system parameter are also

listed.

So you can change single settings and check the settings by the help of this dialog.