Specifications

41 GX Configurator-DP

configuration created from the current project. If both settings match, the following message box is

displayed.

If the settings differ, the following message box is displayed. More detailed information on which

parts of the settings are different, is not provided.

In case any problems occur, for example when reading the configuration from the module, a

general error message is shown.

For QnPRH redundant systems

If the connected PLC is a QnPRH, GXDP automatically checks whether both PLCs of the

redundant system are accessible by using the tracking cable and also checks the current backup

mode. The procedure for verify is adapted according to the result of these tests

1. ‘Backup’ mode and both PLCs connected: the user is asked for confirmation to verify the

configuration of both master modules. If the user confirms, the system is automatically

switched to ‘Separate’ mode and default device tracking is turned off. Then the current

configuration is read from the master in the control as well as in the standby system and

compared with the configuration of the current project..

2. ‘Separate’ mode and both PLCs connected: the user is asked, whether the configuration

of both master modules or only of the one in the locally connected PLC should be

verified. In both cases device tracking is turned off, while the current configuration is

uploaded from the master(s). After the verify, device tracking is enabled again.