Specifications

37 GX Configurator-DP

default transfer setup is automatically added to the project file. With the <Configure> button you

can change the settings both for the default and for a new created transfer setup.

For a more detailed description how to handle a transfer setup see also chapter

Opening the

transfer setup and defining a network connection.

Command Transfer

In the submenu Transfer the user can choose between:

Download to Module...:

download the configuration from the current project to the

connected module.

Verify:

upload the existing configuration from the module and compare it with the current

project.

Upload Config.Image:

read the binary configuration image from the master and store it

in a file

Download Config.Image:

download the configuration image taken from the specified file

to the master module

Command Download to Module…

This item downloads the configuration in the current project to the master module specified in the

transfer setup. The user must confirm the operation, before the download is actually started.

Note:

The FX3U-64DP-M PROFIBUS master can only be updated, if the CPU is stopped. The

CPU can be stopped and restarted automatically during the download, if the user agrees.

If the download has been successful and autorefresh is selected as data transfer method, the

user is asked, whether the autorefresh settings should be updated or not. Depending on the

selection in

CPU Device Access

either the CPU or a file is updated.

For other master modules than A(1S)J71PB92D the note about the mode switch is hidden in the

message box.

Note:

If you use a A(1S)J71PB92D module the user must set the correct operation mode (0 or

E) with the switch on the front of the module.The module will take over the setting of the

mode switch after a CPU reset.