Specifications

77Installation

6. Select "MITSUBISHI ELECTRIC" from the "Manufacturer" List and after that "MITSUBISHI DCP

driver" from the "Network Protocol" List. Then click "OK" to confirm the selection.

The "MITSUBISHI DCP driver" is now added to the protocol list in the dialog "Local Area Connection

Properties".

Note: After adding the driver the operating system must be restarted to enable online operation for

GX Configurator-PN.

4.4 PROFINET Controller Installation

The PROFINET Controller must be in its factory default settings, before the PROFINET I/O firmware

can be installed and started. If the module has been used before or any problems are encountered

during the PROFINET I/O firmware installation, the module must first be set to its factory defaults.

For the detailed procedure see the section 'Troubleshooting - Factory Default Settings'.

To install the PROFINET I/O firmware the CF card received from MITSUBISHI must be inserted in the

CF card slot on the module.

1. reset the module to initiate copying the contents of the CF card to the ME1PN1FW-Q memory

2. wait, until the 7-segment LED shows 'AA', indicating that the script on the CF card has been com-

pleted without an error

3. now remove the CF card and reset the controller

4. start GX Configurator-PN, create a configuration with the correct MAC address of the PROFINET

Controller and enter the IP address you want for the PROFINET Controller.