Specifications

101User Interface
(c) 2013 MITSUBISHI ELECTRIC CORPORATION
Name
Description
Choi-
ces /
Range
Default
Scanning
If checked, the network nodes list is refreshed
every 3 seconds. Otherwise the list is not re-
freshed again.
-
-
MAC Address
Ethernet address of the selected device
-
-
Device Type
Type of the selected device
-
-
Factory Reset
Sends a DCP request to the IO-Device telling it
to restart with its factory default settings. The
result of this command will be displayed in the
Request status field
-
-
Name
Name of the selected device
-
-
Permanent Name
Checked: the IO-Device is to store its new na-
me in non-volatile memory. After the next
power cycle the device must use its new na-
me.
Unchecked: the IO-Device is to store its new
name in volatile memory. After the next power
cycle the device goes back to its old name.
-
-
Apply Name
Sends a DCP request to the IO-Device telling it
to use its new name.
The result of this command will be displayed in
the Request status field.
For further information see 'Naming an IO-Devi-
ce'.
-
-
Addressing Mode
There are three available addressing modes:
DCP: the IO-Controller may change the TCP/IP
configuration of the device. The IO-Controller
will change the TCP/IP configuration of the IO-
Device if it differs from the TCP/IP configuration
of the IO-Device contained in the IO-Controller
configuration.
DHCP: In this mode, the IO-Device obtains its
TCP/IP configuration from a DHCP server. The
criterion for obtaining the TCP/IP configuration
from the DHCP server is configurable in the
‘DHCP Based on’ list.
-
-